GameCube DOL-001/101(USA) Lens Assembly w/Board-Type #2-No Switch-Good-Tested

Description

This is the Lens assembly as pictured.
This is Type #2 which can be
RJB2281B/RJB2281A and/or some with -1 or -2 at the end of the number of the laser board as shown in the last two photos
.
It has the Removable Spindle Ribbon as pictured.
Each shipped is a tested from a fully working Cube.
It has No Switch included.
You install yours.
I have such a high demand for the Switches that I am now only selling that part separate.
Test you laser board POT First before doing anything.
Adjust from 150 to 300 ohms.
I set it fully working when shipped.
Depending on your Exact Games and Motherboard you may need to tweak the POT just a hair either way for best results on your Cube.
They all do the same.
These Always show Metal Age Wear on the side where the Fan Blows.
These are Always a bit dusty.
I do my best to clean each before shipping.
These have two types of Bottom Metal frames of Chrome or Flat Metal.
The Chrome Shows Much More Metal Wear then the Flat Metal as shown in this listing.
The Chrome Metal an this Lens assembly Type #2 was found mostly on the older DOL-001.
Either can be used on DOL-001 or DOL-101.
The board itself is in good clean condition as pictured.
Each has a Security Sticker over Lens Ribbon as pictured.
I have a few of these as pictured.